Suggestions on this pattern

1 points · submitted Jul 2024 by u/VirtualSMF · Troubleshooting

Does anyone have any suggestions where this pattern may be coming from?

This is a voron 2.4 build, relatively new. (No practical prints, just tuning) I'm using superslicer w/ default voron profile, and I was attempting to tune pressure advance. (Same effect from Ellis' profile: Ellis_Decorative_Standard_11mm3) From the looks, I don't see that it actually did anything tho? I used a guide from 3dprintinggeek with the model by fagge on printables.

Any help would be greatly appreciated!!

comments

AutoModerator 1 points · Jul 2024

Hello /u/VirtualSMF,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

Printer & Slicer
Filament Material and Brand
Nozzle and Bed Temperature
Print Speed
Nozzle Retraction Settings

^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

permalink