u/Dapper_Dog3136
-
1points
-
3points
Winching (self.jonboats)
-
2points
Yamaha 200xb (self.Outboards)
-
1points
Predator 670 stalling (self.smallengines)
Dapper_Dog3136
Dapper_Dog3136
Is the 2k just for the rifle or with scope/accessories too?
Dapper_Dog3136
Will do, still trying to figure out the best way to do it. Floating the idea of a portable winch or a come along. But we’ll see
Dapper_Dog3136
Second on the citristrip, on one of my guns I had to do the process twice to get all the paint of though
Dapper_Dog3136
I always just rinse mine really good after I get it on the trailer and never had an issue. If you’re going to leave it in the water for a while you might get some growth on the bottom and would just have to scrub it off. If you really wanted to you could paint the bottom with a copper free bottom paint.
Dapper_Dog3136
I just came from key largo, and honestly depends on what yall plan on doing with the boat. If you want to go offshore then it’s probably not the best conditions. But staying inside the reef in the Atlantic side and into the gulf side would be fine. May get a little spray with the wind but it’s not deep enough to be that rough.
Dapper_Dog3136
How much are you looking to spend?
Dapper_Dog3136
What brands are you looking at getting?
Dapper_Dog3136
I had a 6” fabtech lift on my 2019. I ended up doing a fair bit of towing and it worked ok, but wish I would’ve just stayed with the leveling kit I had. Looks was it was great, so if you’re not doing much towing I would go with the 4”.
Dapper_Dog3136
I’ll have to check that out, thanks! Does it hold well in muddy conditions?
Dapper_Dog3136
I love the Arisaka hand stop
Dapper_Dog3136
I would, it’ll only be what about 20-30 lb difference. The hp max are for coast guard regulations. So if you ever get checked for that which never really happens or could be problems with insurance if you get in a wreck.
Dapper_Dog3136
I’m pretty sure they did that at the 1000 hour service I did. The most recent one was the 300 hour service. Might just bite the bullet and have a mechanic come take a look and check for codes. Would rather be safe then sorry
Dapper_Dog3136
I’ve had it since it had about 300 hours. That’s what I thought it was, but I reset it and then it popped back up a few hours later. Tried to reset one more time and did the same.
Dapper_Dog3136
I had the same issue after I bought my bike. Tried all sorts of filter wrenches to no avail. So I used some big channel lock pliers and those worked the best.
Dapper_Dog3136
Had a 2019 f-150 3.5. Thing was a pain the last year I had it. Had the timing chain go bad, a rear diff leak, and another oil leak that I forgot what caused it. Sold it and got a 250 now, so hopefully have better luck with this.
Dapper_Dog3136
I just started fishing up here with my robalo r222 and it’s been fine with the inshore. Only downside is no trolling motor yet. But it’s small enough to fish close to the flats and big enough to run offshore a little bit to fish the reefs.
Dapper_Dog3136
That’s the boat I’m hoping to get next. Love the layout of them and the ease ability of towing. Have been on quite of few of the bigger contenders and they are sweet boats.
Dapper_Dog3136
The contender 28t are solid boats and can be found for under 200k for a couple years old.
Dapper_Dog3136
I have stock buffer/ spring. But changed trigger, charging handle, adjustable gas block, safety, brace, and grip. I mainly run sellior and bellot and magtech for sub plinking ammo. And phantom defense for the home defense ammo
Dapper_Dog3136
I run the same thing for my bed side except I have the dead air nomad on mine. Changed quite a few things on the rifle too, and have well over a thousand rounds through it without a single malfunction. Thing has been proven to me
I love my Psa 10a1, put over a thousand rounds through it and been perfect. Good accuracy with the right ammo.