u/Dreygon-10

This is super helpful. I’ll have to have a terminal open and watch it. I’ll throw an edit on this post if it gives back anything helpful.

I saw another post mentioning a dying drive, and in this market I’m really hoping it’s not that. Especially since this drive is only about 15 months old.

Can’t wait to plug this bad boy in and short the power grid of the city

I had an 11 pro. It was getting lot of lag, weird freezing, and poor signal no matter where I was (Signal being related to 16 idk). I received a 14 Pro after delays due to back order. So far the only thing I’ve seen is video playback issues, where once the video is done it’s replays super fast with no audio and freezes up for a second.

Otherwise, it’s usual apple doings. “Heh new update make old phone go brrrr.” Maybe I’m wrong and there are poor experiences with the new line too. I can only speak about it to a degree.

A man’s yellow pillow is sacred. Don’t let them take that from you.

I didn’t either till it was needing replacement. Like I said though I’m not to sure about the Gen 1 so I could be entirely off. I have a Gen 2 and Hatchback, that’s like different model squared.

It could be the antenna amplifier going out.

I have a 2018 hatchback, to make a long story short, the radio was almost completely static without being super close to the source. So I brought it into the dealership I had bought it and had them look.

The amplifier was completely corroded and had to be replaced.

I also don’t know a lot about the gen 1 so I could be off by a lot.

I like to think the operator didn’t move the bucket, it just panicked as much as he did.

Awesome, this clears things up. Thank you!

Unfortunately no, it turns on just fine. It displays an image of what can be inferred as a missing floppy drive.

When looking at the 1.44 disks, there’s a two disk set for 6.0.8 and a single disk for 6.0.8L. Am I going to want the two disk 6.0.8?

Edit: or I guess which one is better?

4.2.2

Yeah, my thought is I need to put it back to v1.0.1 then put v1.1.2 back on it.

Long story short I am incredibly new to 3D printing.

I bought the Pro 3 yesterday and the CR Touch attachment, however after I flashed the board to 1.1.2 following this video. As it was ready to start going, the video moved to auto home and mine just sat. I have checked the cables several times and they are all plugged in.

No clue what to do but I’m willing to try anything.

Arson

Different bumper, some custom ones have that hook.

Or just go full tilt and have roughly 3,200 songs you shuffle though

This is it doing a dashboard or service update and is totally normal. My xbox One S does the same thing now and again.

Best approach vehicle is no approach vehicle

Oh my bad I didn’t see the comment you made.