u/lyquid_pcs

Thank you for the compliments!

Oh it's a awesome case no doubt!! I used a corsair 750D magnetic mesh thats on top of the case. Just modified it to fit the Nano panel since I had it available. Home Depot and Lowes have mesh options👍

It's actually a mesh from a corsair 750D. Magnetic mesh thats on top of the case. Modified to fit the Nano S panel. Home Depot or Lowes sells various mesh options to use. I just had that available👌

Oh it definitely took a lot of determination! Implemented some heat shrink as well! That isn't seen ;)

Thanks you! I do have a a lot of photos. I'll have to see about uploading some to imgur

Thanks! I modified the original case front panel myself. I used a dremel tool, hand filed the edges, sanded then painted! 👍

That's great news!

Thanks man! Ya I did know that. Unfortunately, they were out of stock at the time during this build.

Thank you! I spent a lot time and focus on the bends. Key aspect!

Thank you! A lot of thought went into this project! I conquered the mini-ITX custom loop challenge!

Thank you so much!

I personally used Mayhems pastel coolants in previous builds and had great success with them. Never any gunk ups but did leave a white residue on various pieces on the loop which is minimal. May have adjusted their mixes since then though. I'd recommend Mayhems.

Thanks! Yes, a lot of time and focus went into this build no doubt. I had a vision and made sure it came to life!

Thank You! This is the PrimoChill VUE Candy Purple SX! They have opaque purple choices as well as purple transparent coolants!

Thanks! I put a lot of attention in the bend work.

Thank you! Yes! The D5s are killer from EK! Love their products!

Thanks! The brand of purple sleeving is Teleios. The cables were handmade by Wazz Modz! Check him out! His work is outstanding!

Thank you!

Thanks! First watercooling builds are adventures no doubt. Black and purple is killer for sure!

I didn't see your comment before I responded. You may be right. I've had the issue before after cleaning blocks.

I almost had the exact issue it seems but with just one loop on my lastest build. Found out there was two much air in the loop or pump itself. Do you have a functional bleed point? Also did you do any sort of block cleaning prior to placing them in the loop?

All cards are prone to some sag. I'd have to see your configuration but you could make the tube or tubes in between a little longer to help sag support. Not much though. If the tubes are too short it may be pulling downward when tightening the compression fittings. Hope this helps.

Thank you the compliments on Mighty Nano! Lowest maintenance would be a transparent coolant of some sort. You could look at PrimoChill for an Opaque which is a pastel fluid that is usually longer in between maintenance than the Vue.

Thanks for the compliments! Yes, I cut out the original wall in the case to implement the custom pass thru wall. A change no doubt but worked out well!