u/random_rolle

Epic has a mobile store

Caves of lore

Guild quests reset at weekly. So that's a way to see it.

Idleon efficency, idleon toolbox, but best for getting targets to do is scolis autoreview.

Make sure that nozzle / hotend is firm. No loose bits.

Let's hope.

Dawncaster

Printables

Mesh should not affect that. Maybe the walls are too thin?

Worth noting is that klipper now contains built in adaptive meshing. Code is based on kamps adaptive.

Broken wire maybe, when head moves, the wire is broken, so no signal probably.

You'll love dawncaster

Latest klipper has adaptive meshing built in. Rest of kamp can still be useful though.

I have older sp5, using io-mount toolhead, also heard that diamond mount is a good toolhead.

What type of probe? If inductive it could be interference from magnetic fields below plate, like heating etc.

Add sweden to allowed countries please.

Have you tried dawncaster?

Try increasing retraction distance. Or use z-hop. Most likely culprit.

Sounds more like a broken sensor. Check signal cable for breakage. And that you are using the right pin in the config.

Probe_calibrate to set correct z-offset should help.

Make sure that your screw locations are correct in relevant sections. Sensor should be on top of screw. Use only screw...calculate. Make sure to do adjustments with bed at printing temp (and if you use a induction sensor, probably nozzle at print temp too, since temp around sensor can affect measuring)

Tilt adjust can be used with dual screw printers to sync them. But if so do it before a screws calculate. Then repeat both once more.

Adjust pressure advance, possibly lowering corner speed first.

You can change font at themelevel with goodlock.

Most likely the slicer is adding extra end stuff before the macro, and turning of motors. Hence not being homed anymore.

Make sure in cura only end_print is in end code box for the printer.

Quite a lot