u/waffledespizer
-
1points
-
3points
-
1points
-
2points
Nissan - Navara d40 Crank no start (self.AutoMechanics)
-
1points
%5BTECH%5D - [2013] [Nissan - Navara d40] [Crank no start] (self.4x4Australia) [TECH SUPPORT]
-
1points
Nissan navara d40 crank no start (self.4x4Australia) [TECH SUPPORT]
-
3points
Does anyone know what this paint is? (old.reddit.com)
-
0points
Does anyone know what this paint is? (old.reddit.com)
-
2points
-
1points
-
1points
Holden (Chevrolet) Cruze replacement cluster vin programming [Gen1 - Electronics]
-
2points
Holden (Chevrolet) Cruze replacement cluster vin programming [Help & Issues]
waffledespizer
waffledespizer
Thank you very much for the help, just one last question, how long should I leave it on the paint before I start scraping? dont want to leave it too much and damage the paint under
waffledespizer
Thanks for the advice, saw a few guys on youtube removing raptor with this stuff
but after recommendations on the post I will use automotive specialised paint strippers
waffledespizer
Would it be easy to strip just the black layer and keep the bottom white layer clean? also I cant find klean strip paint remove near me but is it a brush on stripper gel or liquid?
waffledespizer
what stripping compound you recommend? saw youtube video using citrus based gel, but is that the best solution?
waffledespizer
it is hard but not very textured, is it realisitic the whole car was painted in tar?
waffledespizer
https://www.aliexpress.com/item/1005006012659800.html I found this one as I said in my previous comment but this doesnt have controllable voltage range its just one output
waffledespizer
u/borax had a very good explanation on how to find a similar power supply, have a look on aliexpress thats where I got mine from but I cant find the exact link, sorry.
waffledespizer
I am confused what this has to do with the post?
waffledespizer
tried it nothing changed
waffledespizer
looking under the usb programmer, I have my my cable hooked to the yellow highlighted pins, if I understood correctly you are telling me to move it to the blue highlighted pins is that right?
I put mine in the yellow ones because it is a 24 series chip and the programmer says to put 24 series chips in there.
waffledespizer
can you please elaborate on whats a MDI or a a clone? the only other tool I have is a xtool d8 scan tool, I also have a generic elm327 obd2 tool.
waffledespizer
I found this in the commodore forum, should be similar process especially because it even uses the same exact chip. but instead of desoldering people say to power on the cluster
is this a common thing or does it seem a bit sketchy?
https://forums.justcommodores.com.au/threads/mylink-vin-eeprom.266357/
Thanks for the great advice!
How long do you reckon I should leave it on before scrapping? don't want it to get through and ruin the paint under